Bob 'N Serge
Make Economical Use of Bobbin Thread
The "New" Bob 'N Serge is designed to fit on any serger machine and is designed to use any/all of your machine bobbin(s),you have stored in
your sewing room. The bob 'n serger is a two piece collection and is made on a hard plastic in white,and clear top with(5),small studs where you
would place your bobbin(s),on each as shown. There is(1),open spool pin hole where the bob 'n serge will sit and rest on by pushing it down on
the spool pin holder as shown.
*Simply remove the back spool of thread off the back spool pin holder,side the Bob 'N Serge over the open hole on the bob 'n serge,place your
bobbin(s), on each small stud as show,with the top Clear plastic cover,insert each thread through the hole with is designed for each bobbin,close
the top clear cover over the bobbin(s),pull some thread out the clear top cover and either tie on the thread from your cone thread you are
using,or simply re-thread your machine. Then from there you are ready to use your Bob 'N Serge and the thread(s),that are on you
bobbin(s),sitting in your sewing room,basket,etc.
No more worries on what can you or what will you do with bobbin(s),with thread on them and that you may have a use for each, and it is easy to
Condition: New in Box
Shipping: This item usually leaves warehouses 2-3 days
Returns: See Our Store Policy
Add to Cart